PirateBayX.jpg

Crocodile Isle Instructions

Setup, Safety, and Takedown Instructions for Crocodile Isle

 
 
Rainforest Rapids - Instructions

Rainforest Rapids - Instructions

 

Setup Instructions

  1. Unfold tarp and position it where you want the bounce house.  Tarp is not recommended if using the bounce house indoors.

  2. Unroll bounce house, starting at the back of the tarp, towards the direction of where the front/pool will be.

  3. Using the provided rubber mallet and stakes, stake down the bounce house (not the tarp). Avoid puncturing the tarp.  

  4. The back of the bounce house has two vent tubes, one that is long and will attach to the blower/fan, and one that is short.  Tie the short vent tube shut using a single granny knot. (This allows the tube to come untied if there is too much pressure.)

  5. Slip the long vent tube over the edge of the blower/fan.  (There is an elastic around the mouth of the tube, but it should go completely over the lips of the blower/fan.  Tie the long vent tube shut using a standard shoelace bowtie knot.

  6. Plug in the blower/fan. ENSURE THE BLOWER POWER CORD IS IN A PLACE THAT WILL NOT GET WET.

  7. Press the breaker "RESET" button on the blower plug.

  8. Turn the blower/fan on using the rocker switch that is under the protective transparent vinyl cover.  The bounce house should inflate within two minutes.  Leave the blower/fan on when the bounce house is in use.

  9. Attach the water hose accessories using the provided Velcro straps. See photos below:

8a. Attach the sprinkler above the top of the right slide using Velcro. Secure the hose using the additional Velcro straps.

8a. Attach the sprinkler above the top of the right slide using Velcro. Secure the hose using the additional Velcro straps.

8b. Continue securing hose from the top of the slide towards the back of the slide and then down the back corner. The hose attachment is at the bottom.

8b. Continue securing hose from the top of the slide towards the back of the slide and then down the back corner. The hose attachment is at the bottom.

8c. Continue attaching hose around the front of the left slide. Attach the sprinkler above the top of the right slide using Velcro.  8e. Attach garden hose and gently turn on water (1/2 turn should work). EXCESS WATER PRESSURE CAN DAMAGE HOSES AND C…

8c. Continue attaching hose around the front of the left slide. Attach the sprinkler above the top of the right slide using Velcro.
8e. Attach garden hose and gently turn on water (1/2 turn should work). EXCESS WATER PRESSURE CAN DAMAGE HOSES AND CONNECTORS.

SAFETY INSTRUCTIONS

  • ENSURE BLOWER POWER CORD IS IN A PLACE THAT WILL NOT GET WET.

  • No food, drink or chewing gum

  • No shoes, belts, watches, glasses, jewelry, badges (or anything else with sharp edges)

  • No face paints, party poppers, colored streamers, or silly string

  • No smoking on or nearby

  • No barbecues nearby

  • No climbing, hanging, or sitting on walls

  • A responsible adult must supervise at all times

  • Avoid overcrowding. Limit numbers according to the age and size of children using it. Avoid large and small children using it at the same time

  • No pushing, colliding, fighting, or behaving in a manner likely to injure or cause distress to others

  • No pets, toys, or sharp instruments

  • No bouncing on the front safety step

  • Do not allow children on Bounce House while inflating or deflating

  • No somersaults

  • In the event the blower/fan stops working, please ensure all users get off Bounce House immediately and calmly. Check breaker and make sure blower tube (long) or deflation tube (short) has not come undone.

  • DO NOT allow children to slide down the water slide head-first.

  • DO NOT let children play on Bounce House without adult supervision.

TAKEDOWN INSTRUCTIONS

  1. Turn off garden hose and disconnect from garden hose from bounce house hose.

  2. Turn off the blower/fan.

  3. Drain water from pool area by stepping on bumper (surrounding pool) with both feet to allow water to escape.  Use broom to sweep out excess water.

  4. Turn on blower/fan to re-inflate house.  Let blower run for 30-60 minutes to help air-dry slide and bounce section.  Try to get the bounce house as dry as possible before continuing with next step.  If bounce house is wet/damp when folded, please notify us when returning it, so we can dry it out further.

  5. Turn off blower/fan again.

  6. Untie both air tubes and remove the long tube from the blower.

  7. Let the air escape from the bounce house.  It will not completely escape on it’s own.

  8. Pull out the stakes and clean off any loose dirt/grass.

  9. Fold the bounce as shown in diagram below.  (This is best done with two people.)  Between Steps 2 and 3, you will likely need to push the air out towards the vent tubes.

    *** THE BEST WAY TO GET THE AIR OUT WILL MAKE YOU FEEL SILLY, BUT IT IS FOR YOU (AN ADULT) TO LIE DOWN NEAR THE FRONT STEP AND ROLL SLOWLY TOWARDS THE VENT TUBES!!! YOUR CHILDREN *WILL* LAUGH AT YOU. HAVE FUN AND ENJOY IT.

  10. Roll the bounce house up, pressing it on with your knees to force the air out as you go.

  11. Use the provided straps to secure the bounce house in a rolled-up position.

  12. Fold up the tarp, taking clear to brush off grass/dirt/mud as much as possible.

  13. Place the tarp, stakes (8), rubber mallet, water home attachment and bounce house back into the duffel bag. 

  14. You’re done!

 
Folding the Crocodile Isle House

Folding the Crocodile Isle House